Remember These Things When You Repair Hole In Copper Hot Water System

Having a hole in your copper hot water system is a very common issue and in most cases you don’t need to call a plumber because you can easily repair it by yourself. However, when you repair holes, you have to keep the following things in mind.

 

Always turn off the power: Before you start any repair work with your hot water system, it is always a good idea to turn off the power supply from the main switch. This precautionary measure will keep you away from accidents and makes you comfortable with your task.

 

Identify the leak first: Before emptying your tank, it is important that you find out the leak first. It is always easy to find the leak with running water instead of an empty tank. When you find it out, make sure you put a mark on the leaky area so you do not lose it after emptying the tank.

 

Empty the tank: Now empty the tank before you continue to repair the hole. Here, repairing method may vary depending on the problem. If you have a minor problem you can close it using a rubber seal and clamp, else you can just cut that section of the pipe and replace it with a new one.

 

Also, when you try to repair holes in copper, be careful as hot water or steam might burst out from the system. So it is very important to think of safety when doing this kind of repair or with any other repairs. Keeping this in mind will keep you away from harm’s way.